The switch software monitors switch conditions on a per-port or a switch basis. How to use a Secure Digital (SD) flash memory module (SD card)Ĭonfiguring Switch Alarms Information About Switch Alarms.How to Configure Enhanced Object Tracking.

Configuring Cisco IOS IP SLAs Operations.Configuring Embedded Event Manager (EEM).Configuring IPv6 access control lists (ACLs).Configuring Multicast Listener Discovery (MLD) snooping.Configuring Multicast Source Discovery Protocol (MSDP).Configuring Simple Network Management Protocol (SNMP).Configuring UniDirectional Link Detection (UDLD).One-to-one (1:1) Layer 2 Network Address Translation (NAT).Configuring LLDP, LLDP-MED, and Wired Location Service.

How to Configure Internet Group Management Protocol (IGMP) and Multicast VLAN Registration (MVR).

Dynamic Address Resolution Protocol (ARP).

Configuring the FlexLinks and the MAC Address-Table Move Update.

Configuring Resilient Ethernet Protocol.

Configuring Optional Spanning-Tree Features.

How to Configure Spanning Tree Protocol (STP).

Configuring SGT Exchange Protocol over TCP (SXP) and Layer 3 Transport.

Configuring SGACL Monitor Mode and SGACL Logging.

Configuring IEEE 802.1x Port-Based Authentication.

Configuring Switch-Based Authentication.

Configuring Precision Time Protocol (PTP).

How to Create and Manage Switch Clusters.

How to Setup and Use the Cisco Configuration Engine.Initial Switch Configuration (IP address assignments and DHCP autoconfiguration).The Cisco IOS command-line interface (CLI).If you want us to investigate the issue further then please send us the complete SNMP walk from the device which also includes values of above mentioned OIDs. Please do let us know if you have any further question on the topic. We recommend to contact vendor of the device if you confirm that device return incorrect value for anyone of the OIDs. The issue is usually in entSensorPrecision, the device should return 0 to be the result 34. The formula to calculate the resulting value is: entSensorValue * exponent * 10 raised to power of (minus entSensorPrecision) = result 34 * 1 * 10^(-1) = 3,4 The temperate is out by a factor of 10, logged a case with solarwinds and got told to speak to cisco about it, case number: 592189Īccording to SW Support this is how they calculate the temperature ,įurther to our earlier communication, I have received the below mentioned explanation we the application calculates the temperature:ĮntSensorScale (9 which is equal to 1 according to table-exponent) Solarwinds math on getting the temperature is wrong, I went through and checked it myself

Cisco switch show temperature